分享资料个
1 Introduction
This document describes a non-isolated， power factor corrected， low THD， high-efficiency
LED driver designed to drive a 144 V LED string at 180 mA from an input voltage range
of 90 VAC to 265 VAC.
The LYTSwitch-4 has been developed to cost effectively implement a single-stage power
factor corrected LED driver combined with primary-side constant-current control. The
LYTSwitch-4 controller is optimized for LED driver applications and requires minimal
external parts. It provides control of output current without the use of an optocoupler.
The LYTSwitch-4 monolithically combines the 725 V power MOSFET and controller. The
controller consists of an oscillator， PWM， 6 V regulator， over-temperature protection，
frequency jittering， cycle-by-cycle current limit and other protection features plus a charge
controller for output CC （constant current） control.
The LYTSwitch-4 provides a sophisticated range of protection features including autorestart for control loop open/short faults and output short-circuit conditions. The accurate
hysteretic thermal shutdown ensures safe PCB temperatures under all conditions.
The non-isolated power factor corrected buck-boost design presented in this report
shows how LYTSwitch-4 dramatically simplifies off-line， high-efficiency， power factor
corrected LED driver design and enables an EN 61000-3-2 Class C compliant
implementation of a very high efficiency， high output voltage LED driver.
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
全部0条评论
快来发表一下你的评论吧 !
