The signal lines XIN and XOUT canalso be used as multipurpose I/Os or
as a digital frequency input.
8、It should be noted that there are two 0 ohms resistors (R28 and R29)
that extend the crystal pin leads to the single-in-line break out connector
(J2)。 In case of oscillator signal distortion hich leads to a fault indication
at the basic clock module, these resistors can be used to disconnect
connector J2 from the oscillating lines.
R28 和 R29 0 欧,可移除以断开与 J2 的连接
以上从 MSP-EXP430G2 LaunchPad Experimenter Board User‘s
Guide.pdf (Literature Number: SLAU318)里面摘录,这些我认为比
较重要的。
声明:本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人,不代表电子发烧友网立场。文章及其配图仅供工程师学习之用,如有内容侵权或者其他违规问题,请联系本站处理。 举报投诉
全部0条评论
快来发表一下你的评论吧 !