分享资料个
The AD5379 contains 40 14-bit DACs in one CSPBGA package. The AD5379 provides a bipolar output range determined by the voltages applied to the VREF（+） and VREF（−） inputs. The maximum output voltage span is 17.5 V， corresponding to a bipolar output range of −8.75 V to +8.75 V， and is achieved with reference voltages of VREF（−） = −3.5 V and VREF（+） = +5 V. The AD5379 offers guaranteed operation over a wide VSS/VDD supply range from ±11.4 V to ±16.5 V. The output amplifier headroom requirement is 2.5 V operating with a load current of 1.5 mA， and 2 V operating with a load current of 0.5 mA. The AD5379 contains a double-buffered parallel interface in which 14 data bits are loaded into one of the input registers under the control of the WR， CS， and DAC Channel Address Pins A0 to A7. It also has a 3-wire serial interface that is compatible with SPI®， QSPI™， MICROWIRE™， and DSP® interface standards and can handle clock speeds of up to 50 MHz. The DAC outputs are updated upon reception of new data into the DAC registers. All the outputs can be simultaneously updated by taking the LDAC input low. Each channel has a programmable gain and an offset adjust register. Each DAC output is gained and buffered on-chip with respect to an external REFGND input. The DAC outputs can also be switched to REFGND via the CLR pin.
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
全部0条评论
快来发表一下你的评论吧 !
