分享资料个
The ADG738 and ADG739 are CMOS analog matrix switches with a serially-controlled 3-wire interface. The ADG738 is an 8-channel matrix switch， while the ADG739 is a dual 4-channel matrix switch. On resistance is closely matched between switches and very flat over the full signal range. FUNCTIONAL BLOCK DIAGRAMS Figure 1. Figure 2. The ADG738 and ADG739 utilize a 3-wire serial interface that is compatible with SPI™， QSPI™， MICROWIRE®， and some DSP interface standards. The output of the input shift register， DOUT， enables a number of these parts to be daisy-chained. On power-up， the internal input shift register contains all zeros and all switches are in the off state. Each switch conducts equally well in both directions when on， making these parts suitable for both multiplexing and demultiplexing applications. As each switch is turned on or off by a separate bit， these parts can also be configured as a type of switch array， where any， all， or none of the eight switches may be closed at any time. The input signal range extends to the supply rails.
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
全部0条评论
快来发表一下你的评论吧 !
