分享资料个
The ADP5020 provides a highly integrated power solution that includes all of the power circuits necessary for a digital imaging module. It comprises two step-down dc-to-dc converters， one LDO， and a power sequence controller. All dc-to-dc converters integrate power pMOSFETs and nMOSFETs， making the system simpler and more compact and reducing the cost. The ADP5020 has digitally programmed output voltages and buck converters that can source up to 600 mA. A fixed frequency operation of 3 MHz enables the use of tiny inductors and capacitors. The buck converters use a voltage mode， constant-frequency PWM control scheme， and the synchronous rectification is implemented to reduce the power loss. The Buck 1 regulator operates at up to 93% efficiency. The ADP5020 provides high performance， reduces component count and size， and is lower in cost when compared to conventional designs. The ADP5020 runs on input voltage from 2.4 V to 5.5 V and supports one-cell lithium-ion （Li+） batteries. The high performance LDO maximizes noise suppression. The ADP5020 can be activated via an I2 C® interface or through a dedicated enable input. During logic-controlled shutdown， the input is disconnected from the output source， and the part draws 1 μA typical from the input source. Other key features include undervoltage lockout to prevent deep-battery discharge and soft start to prevent input current overshoot at startup. The ADP5020 is available in a 20-lead LFCSP.
声明：本文内容及配图由入驻作者撰写或者入驻合作网站授权转载。文章观点仅代表作者本人，不代表电子发烧友网立场。文章及其配图仅供工程师学习之用，如有内容侵权或者其他违规问题，请联系本站处理。 举报投诉
全部0条评论
快来发表一下你的评论吧 !
